How to Make a Race Medal Holder

Follow these steps to use a Kudos Coaster Plus to make a running medal holder for your favorite race medal. For steps to include a ribbon inside the display, see how to display running medals with a ribbon. And afterwards, be sure to make a DIY photo coaster with your favorite race photo!

How to Make a Race Medal Holder Step 1

Step 1

Pop off the top and remove all Tru-Fit inserts but leave the metal plate in the base.

How to Display Race Medals Step 2

Step 2

Review the Tru-Fit insert colors and pick the one that best complements your medal. Place your medal on top of that Tru-Fit insert and set aside.

Make a Running Medal Holder Step 3

Step 3

Replace a few of the remaining Tru-Fit inserts back into the base, above the metal plate.

Display Running Medals Step 4

Step 4

Place the medal and insert combo you set aside on top of the other Tru-Fit inserts. Bring the top edge of the base up to eye level to make sure you can just barely see the top of your medal above the rim. If you can’t see it, or there is too much showing, try adding or removing another Tru-Fit layer.

Race Medal Display Case Step 5

Step 5

Align your medal on top so it’s perfectly centered and place the top onto the base until it fits snug. You should hear a snap when it’s properly sealed. Your medal should fit snug against the top to avoid rattling. If it doesn’t, re-open the coaster and add another Tru-Fit insert and then re-close. If you’re forcing it to close, and you don’t hear a snap, try removing a Tru-Fit insert and then re-closing.

Celebrate you, enjoy your drinks on us and remember to smile year-round!

Leave a Reply